Plasma Cutting System 12 Amp 115V with Built-In Compressor

Home l Contact Us l Order Info l Privacy Policy

Home > ShopEquip > Plasma Cutters > Plasma Cutting System 12 Amp 115V with Built-In Compressor

• The FP18 is a 110V 1/8" capactity plasma cutting system with an on board air compressor. Simply plug the unit into a 110 volt outlet and the system will 10 cut gauge, 1/8" mild steel at 9 IPM. No more air compressor to haul around. The internal compressor insures clean, dry air with no need for a filter.

Features:

• Operates on standard 115 volt current

• Built-in air compressor - Portable & Self Contained!

• Cuts mild steel, stainless steel, aluminum, copper or brass

• Weighs only 55 lbs!

• Features a "pilot-arc" that burns through paint and rust

• Drag tip system allows placement in tight spaces and awkward locations

• Substantially reduces joint prep time - Warping does not occur and slag removal is not required.

• Long consumable life/low cost per cut

• Firepower automatic torch restart system

• One year Firepower warranty

Comes complete with: 20 ft. genuine Firepower drag torch system, 6 ft. power cord with plug, (5) 1445-0031 cutting tips, (3) 1445-0016 electrodes, (1) 1445-0017 gas distributor, instruction manual.

Specifications:

Input voltage - 115V 60HZ

Input current - 20 Amps

Maximum output - 18 Amps

Rated output - 12 Amps

Rated duty cycle - 30%

Maximum cutting capacity - 1/8"

Cutting speed (mild steel) - 20ga./60" Per Minute, 18ga./60" PM, 10ga./12" PM, 1/8"/9" PM

Weight - 55 lbs.

Untitled Document

Got-Tools.com
805 S Fremont Ave.
Alhambra, CA 91803
admin@got-tools.com